RTK Base Station Setup

This section will explains how to configure your base station settings when selecting RTK correction in your console.

GPS Settings screen

System150 GX-45_RTK Base_FIG 1

1. Select System 150 GX-45_Correction Sources_FIG 1 to access the Select Correction System screen.

Select Correction System screen

System150 GX-45_RTK Base_FIG 2

2. Select RTK from the list using the up and down arrows.

3. Select the green tick to confirm. You will be taken to the RTK Protocol Selection screen.

Select RTK Protocol screen

System150 GX-45_RTK Base_FIG 3

4. Select an RTK Protocol from the list using the up and down arrows.

5. Select the green tick to confirm. You will be taken to the Configure Arwest screen.

Configure Arwest screen

System150 GX-45_RTK Base_FIG 4

6. Select Frequency to set the UHF frequency your base station is set to.

7. Select Net ID to set the Net ID. This is usually set at 1 by default. If you are using a networked base station array you may need to change this value.

8. Select the green tick to confirm. A screen will appear indicating that the modem is being set up.

Once the modem is set up, you will be returned to the GPS settings screen.

FacebookTwitterEmailShare